Fabrication of a Hot-Embossing Metal Micro-Mold Through Laser Shock Imprinting

As a technology for polymer surface fabrication, roll-to-roll hot embossing has been widely used because of its advantages, such as its low cost and high efficiency. However, the metal micro-mold is a major factor that determines the hot embossing of the polymer. In this study, a new metal micro-mold manufacturing method is proposed. The metal micro-mold is produced using laser shock imprinting (LSI) on the surface of metal foil. It has the characteristics of good thermal stability and high strength. During our LSI experiment, the strength of the mold increased after laser shocking. In this study, copper foils of different thicknesses were selected for LSI experiments. Through the analysis of the profile and forming depth of the microstructure, combined with the numerical simulation of the forming mechanism of copper foils with different thicknesses using ABAQUS software(Abaqus 2021), a copper foil with a flat back was selected as the final metal micro-mold. On this basis, copper molds with different microstructure shapes were created. Then, the mold was used in the hot-embossing experiment to manufacture the microstructure on the surface of polyethylene terephthalate (PET) and to study the fidelity and integrity of the molded microstructure. The deformation resistance of the copper mold under hot-embossing conditions was verified through a nano-indentation experiment. The final results show that the metal micro-mold produced via LSI had a high accuracy and molding stability and has potential applications in the field of roll-to-roll hot embossing.