» Articles » PMID: 36843961

Effect of Disinfectants and Manual Wiping for Processing the Cell Product Changeover in a Biosafety Cabinet

Overview
Journal Regen Ther
Date 2023 Feb 27
PMID 36843961
Authors
Affiliations
Soon will be listed here.
Abstract

Introduction: The process of cell product changeover poses a high risk of cross-contamination. Hence, it is essential to minimize cross-contamination while processing cell products. Following its use, the surface of a biosafety cabinet is commonly disinfected by ethanol spray and manual wiping methods. However, the effectiveness of this protocol and the optimal disinfectant have not yet been evaluated. Here, we assessed the effect of various disinfectants and manual wiping methods on bacterial removal during cell processing.

Methods: The hard surface carrier test was performed to evaluate the disinfectant efficacy of benzalkonium chloride with a corrosion inhibitor (BKC + I), ethanol (ETH), peracetic acid (PAA), and wiping against endospores. Distilled water (DW) was used as the control. A pressure sensor was employed to investigate the differences in loading under dry and wet conditions. The pre-spray for wiping was monitored by eight operators using a paper that turns black when wet. Chemical properties, including residual floating proteins, and mechanical properties, such as viscosity and coefficient of friction, were examined.

Results: In total, 2.02 ± 0.21-Log and 3.00 ± 0.46-Log reductions from 6-Log CFU of endospores were observed for BKC + I and PAA, respectively, following treatment for 5 min. Meanwhile, wiping resulted in a 0.70 ± 0.12-Log reduction under dry conditions. Under wet conditions, DW and BKC + I showed 3.20 ± 0.17-Log and 3.92 ± 0.46-Log reductions, whereas ETH caused a 1.59 ± 0.26-Log reduction. Analysis of the pressure sensor suggested that the force was not transmitted under dry conditions. Evaluation of the amount of spray by eight operators showed differences and bias in the spraying area. While ETH had the lowest ratio in the protein floating and collection assays, it exhibited the highest viscosity. BKC + I had the highest friction coefficient under 4.0-6.3 mm/s; however, that of BKC + I decreased and became similar to the friction coefficient of ETH under 39.8-63.1 mm/s.

Conclusions: DW and BKC + I are effective for inducing a 3-Log reduction in bacterial abundance. Moreover, the combination of optimal wet conditions and disinfectants is essential for effective wiping in specific environments containing high-protein human sera and tissues. Given that some raw materials processed in cell products contain high protein levels, our findings suggest that a complete changeover of biosafety cabinets is necessary in terms of both cleaning and disinfection.

Citing Articles

Changeover method for biosafety cabinets using ozone gas.

Mizuno M, Suda D, Matsumura C, Sekiya I PLoS One. 2025; 20(1):e0318006.

PMID: 39874382 PMC: 11774351. DOI: 10.1371/journal.pone.0318006.


Cleaning methods for biosafety cabinet to eliminate residual mycoplasmas, viruses, and endotoxins after changeover.

Mizuno M, Kimbara S, Ichise H, Ishikawa N, Nishihara Y, Nishio M Regen Ther. 2024; 28:73-80.

PMID: 39703815 PMC: 11655690. DOI: 10.1016/j.reth.2024.11.020.


Decreasing electricity costs of clean room for cell products during non-operation.

Mizuno M, Abe K, Kakimoto T, Hasebe H, Sekiya I Regen Ther. 2024; 26:1117-1123.

PMID: 39635580 PMC: 11614862. DOI: 10.1016/j.reth.2024.11.002.


Evaluation of cleaning methods for change-over after the processing of cell products to avoid cross-contamination risk.

Mizuno M, Yori K, Takeuchi T, Yamamoto T, Ishikawa N, Kobayashi M Regen Ther. 2024; 26:489-495.

PMID: 39131505 PMC: 11315063. DOI: 10.1016/j.reth.2024.07.002.


Operator-derived particles and falling bacteria in biosafety cabinets.

Mizuno M, Abe K, Kakimoto T, Hasebe H, Kagi N, Sekiya I Regen Ther. 2024; 25:264-272.

PMID: 38304617 PMC: 10831277. DOI: 10.1016/j.reth.2024.01.001.


References
1.
Merchel Piovesan Pereira B, Tagkopoulos I . Benzalkonium Chlorides: Uses, Regulatory Status, and Microbial Resistance. Appl Environ Microbiol. 2019; 85(13). PMC: 6581159. DOI: 10.1128/AEM.00377-19. View

2.
Costa D, de Oliveira Lopes L, Hu H, Tipple A, Vickery K . Alcohol fixation of bacteria to surgical instruments increases cleaning difficulty and may contribute to sterilization inefficacy. Am J Infect Control. 2017; 45(8):e81-e86. DOI: 10.1016/j.ajic.2017.04.286. View

3.
Chihara R, Kitajima H, Ogawa Y, Nakamura H, Tsutsui S, Mizutani M . Effects of residual HO on the growth of MSCs after decontamination. Regen Ther. 2018; 9:111-115. PMC: 6222977. DOI: 10.1016/j.reth.2018.08.003. View

4.
Sekiya I, Katano H, Mizuno M, Koga H, Masumoto J, Tomita M . Alterations in cartilage quantification before and after injections of mesenchymal stem cells into osteoarthritic knees. Sci Rep. 2021; 11(1):13832. PMC: 8257723. DOI: 10.1038/s41598-021-93462-8. View

5.
Watanabe K, Otabe K, Shimizu N, Komori K, Mizuno M, Katano H . High-sensitivity virus and mycoplasma screening test reveals high prevalence of parvovirus B19 infection in human synovial tissues and bone marrow. Stem Cell Res Ther. 2018; 9(1):80. PMC: 5870688. DOI: 10.1186/s13287-018-0811-7. View