Influence of Sterilization on the Mineralization of Titanium Implants Induced by Incubation in Various Biological Model Fluids

The aim of this work was to investigate the effect of the sterilization processes on the mineralization of titanium implants induced by incubation in various biological model fluids. Titanium samples were submitted to the following sterilization processes used for implant materials: steam autoclaving, glow discharge Ar plasma treatment and gamma-irradiation. The modification of the treated surfaces was evaluated by contact angle determinations, X-ray photoelectron spectroscopy (XPS), laser profilometry and X-ray diffraction. The most significant modifications were detected on the wettability: while the samples treated with Ar plasma became highly hydrophilic (water contact angle approximately 0 degrees), gamma-irradiation and steam sterilization induced an increase in the hydrophobicity. After being sterilized, the samples were incubated for one week in three biological model fluids: Hanks' Balanced Salt Solution, Kokubo's simulated body fluid (SBF) and a fluid, designated by SBF0, with the same composition of SBF but without buffer TRIS. The level of mineralization of the incubated Ti samples, assessed by dynamic contact angle analysis, scanning electron microscopy, electron dispersive spectroscopy and XPS, indicated that the early stages of mineralization are essentially independent of the sterilization method. In contrast, the incubating fluid plays a determinant role, SBFO being the most efficient medium for biomineralization of titanium.