» Articles » PMID: 35425538

Metal Oxide Nanoparticle-modified ITO Electrode for High-performance Solution-processed Perovskite Photodetectors

Overview
Journal RSC Adv
Specialty Chemistry
Date 2022 Apr 15
PMID 35425538
Authors
Affiliations
Soon will be listed here.
Abstract

Low dark current density plays a key role in determining the overall performance of perovskite photodetectors (PPDs). To achieve this goal, a hole transport layer (HTL) on the ITO side and a hole blocking layer (HBL) on the metal electrode side are commonly introduced in PPDs. Unlike traditional approaches, we realized a high-performance solution-processed broadband PPD using metal oxide (MO) nanoparticles (NPs) as the HBL on the ITO electrode and PCBM as another HBL on the metal electrode side to reduce the device dark current. The PPDs based on TiO and SnO NP-modified layers show similar device performances at -0.5 V: a greater than 10 on/off ratio; over 100 dB linear dynamic range (LDR) under different visible light illumination; around 0.2 A W responsivity (); greater than 10 jones detectivity (*); and ∼20 μs rise time of the device. The MO NP interfacial layer can significantly suppress charge injection in the dark, while the accumulated photogenerated charges at the interface between the MO layer and the perovskite layer introduce band bending, leading to dramatically increased current under illumination. Therefore, the dark current density of the devices is significantly reduced and the optical gain is drastically enhanced. However, after UV illumination, the dark current of the TiO device dramatically increases while the dark current of the SnO device can stay the same as before since the UV illumination-induced conductivity and barrier height changes in the TiO layer cannot recover after removing the UV irradiation. These results indicate that the TiO NP layer is suitable for making a vis-NIR photodetector, while the SnO NP layer is a good candidate for UV-vis-NIR photodetectors. The facile solution-processed high-performance perovskite photodetector using MO NP-modified ITO is highly compatible with low cost, flexible, and large-area electronics.

References
1.
Dou L, Yang Y, You J, Hong Z, Chang W, Li G . Solution-processed hybrid perovskite photodetectors with high detectivity. Nat Commun. 2014; 5:5404. DOI: 10.1038/ncomms6404. View

2.
Fang Y, Huang J . Resolving Weak Light of Sub-picowatt per Square Centimeter by Hybrid Perovskite Photodetectors Enabled by Noise Reduction. Adv Mater. 2015; 27(17):2804-10. DOI: 10.1002/adma.201500099. View

3.
Cho H, Jeong S, Park M, Kim Y, Wolf C, Lee C . Overcoming the electroluminescence efficiency limitations of perovskite light-emitting diodes. Science. 2016; 350(6265):1222-5. DOI: 10.1126/science.aad1818. View

4.
Stevanovic A, Buttner M, Zhang Z, Yates Jr J . Photoluminescence of TiO2: effect of UV light and adsorbed molecules on surface band structure. J Am Chem Soc. 2011; 134(1):324-32. DOI: 10.1021/ja2072737. View

5.
Shao Y, Xiao Z, Bi C, Yuan Y, Huang J . Origin and elimination of photocurrent hysteresis by fullerene passivation in CH3NH3PbI3 planar heterojunction solar cells. Nat Commun. 2014; 5:5784. DOI: 10.1038/ncomms6784. View