Torque and Surface Mechanomyogram Parallel Reduction During Fatiguing Stimulation in Human Muscles

The purpose of the study was to verify, by means of torque and mechanomyogram (MMG) compared analysis, the validity of MMG as a tool to investigate the contractile changes due to localized muscular fatigue induced by stimulation protocols usually employed for sport training and rehabilitation programs. Ten healthy sedentary subjects participated in the study. Torque produced by the dominant biceps brachii (BB) and vastus lateralis (VL) during transcutaneous stimulated contractions has been recorded by a load cell strapped to the subjects' wrist and distal one-third of the tibia, respectively. MMG was detected over the muscle bellies during a monopolar supramaximal stimulation of the main motor point. After potentiation, the fatiguing stimulation was administered. It consisted of 50 cycles, with 2 s of 50 Hz and 25 s of 2 Hz. Averaged normalized values of peak torque (pT) and MMG peak-to-peak (MMG-pp) of the subjects group decreased from their initial 100% values to 55% (pT) and 60% (MMG-pp) for BB and to 43% (pT) and 47% (MMG-pp) for VL. The pT% and MMG-pp% changes throughout the stimulation protocol presented high correlation (BB: R=0.95, P<0.001; VL: R=0.94, P<0.001). This correlation suggests that MMG could be used to follow muscle mechanical fatigue development when torque output is not or hardly detectable such as during electrical stimulation programs employed for sport training or rehabilitation protocols.